The Manco Factory installed Comet 30 Series Torque Converter Drive Systems on the 5hp Manco 285 Dingo Go Karts and the 6hp Dingo 286 Go Karts built from 1995 through 2003. The Asymmetric 30 Series Torque Converters use a 3/4" top width belt that's flat on one side and angled on the other side. The early Dingo Go Karts, built prior to 1995, were equipped with Asymmetric Comet CAT99 Torque Converters that used a 5/8" top width belt. Comet CAT99 Torque Converters are obsolete, but the 5/8" CAT99 Belts are still available.

You'll find Dingo Parts throughout our website.

The last Dingo Go Karts, sold in 2003, were equipped with a 7/8" Hex Shaped Axle.

Overhead Bars: This Dingo Parts Breakdown can be used to order replacement parts, even if your kart does not have a Full "Overhead Cage" that goes all the way down to the front bumper. The Older 5hp Dingo Karts were equipped with an "Engine Cage" which covers the engine area only, not the Person.

Brakes: Some of the the Older Dingo Karts were equipped with Band Brakes instead of the mechanical disc brakes shown here. Brake bands are shaped like a horseshoe and wrap around a drum that mounts directly on the axle.

Front Rims: If your Dingo is equipped with the discontinued two piece, cast aluminum rims on the front end, Visit the Rims Page to order two piece aluminum alloy "Tri Star Rims".

Paint Colors: Dingo Karts come in several different colors. Black, yellow and purple were the most popular. The Manco Products Name, Model Number; 285 or 286 and or Serial Number is located on a silver sticker on the floorpan of the kart, under the steering wheel area.